Geeetech

Hi,

Brain fart, but how do you reset the home position for the X/Y/Z axis after replacing the TMC2208?

It took so long for the new parts to come that I have completely forgotten how to use my A10T!

Any help would be great!!

Hi, So after finding out how to perform some of my own maintenance after having many issues with my A10T and its firmware, I have found Vert(abreak) online and discovered how to flash over new firmware. After doing some investigation I am just perfecting the firmware and I need to know if the A10T i...

Hi, I have even removed Repetier-Host off my computer, downloaded a new version, installed and configured to meet the A10T requirements and I am still getting issues. I even downloaded the A10T repetier-host Configuration file and this still hasn't changed the issue, although I note that the A10T re...

mt690ju wrote: ↑

Fri Jul 31, 2020 4:52 am

Definitely looks like under-extrusion.

I managed to right this issue, now I am having some other issues printing.

See here https://www.geeetech.com/forum/viewtopi ... 98&t=70988

Hi RitchievanDaal I have done all but step 3 on your list over the past week (as I am not too good with electrical stuff unless it is plug and play or basic home electrics) and yet I still get shifts in the layers. It can't really be anything else other than something to do with the firmware/softwar...

Hi, So after fixing up the extraction issue that I had, my A10T worked pretty well up until it started to change position on the X and Y axis during printing. At first I thought that it may be due to no adhesion, but as you can see here the item is firmly in place on the bed and has not changed posi...

Hi, Thank you for your both for assistance, I will give both methods a try and see if they work. Being a relative new person to doing this kind of adjustments to a printer, would you possibly have any pictures that could assist me in doing the work? I would like to ensure that I am not setting it up...

Hi, After having my motherboard fail and getting a replacement sent out fro Geeetech, I installed it into my A10T and also installed at 3DTouch at the same time. I flashed the firmware over and then went to continue printing with my printer.........only to discover that the quality has diminished to...

Hi, So after discovering a blockage in one of my filament tubes, I took the hot end apart after reading about the steel balls located at the end of each tube to find out how much PLA was stuck in the blocked tube. After putting the head etc back together I powered the unit on only to smell burning e...