Geeetech

Hi!
I am restoring an A10M. Great printer!
But....anyone have the scheme of connector? Only of this CONNECTOR: https://ibb.co/whqDs4v
Thank you very much!!

Tomorrow i'll write a small tutorial. I need 4 days for this work because i have not any guide. With a tutorial you can do this work in a couple of hour.

Hi!
I installed the mainboard SKR 1.4. turbo on my A10M and everything is ok! I am very happy.
But only 1 questio.I want to upload the HEX file of A10M in the download area in this site. But how can upload a HEX file in SKR??

Thank you!

Hi! I have installed SKR 1.4. all is ok but i dont't know how connect th eextruder motor In motor is 4 cables black,red,green and blue. How is conneced on SKR? THANK you very much!!

Hi!
I must to change the cable and connector of my great a10M. Can you someone tell me how th cable is wired on the motor? Pin 1 is? pin2 is? etc etc Thank you very very much!

Hi! My motherboard of A10M is broken (i broak it by error.My mistake). I replace it with Arduino mega and ramps. I Load the Marlin 1.1.8 into Arduino ad it is ok. But if i load the file HEX i founded in Geeetech dowload pages ,nothing happens. I uploaded with cura and seems all ok. But on displaty a...

Hi!
If i unplugged the termistor the temperature on display is always 70.

Nothing happens if i unplugged the cable.

Hi! Yes. If i unplugged the termistor the temperature is -14.But the problem is not the extruder temperature. The problem is the BED temperature. On display is always 70 or 71. If i unplugged the cable ob motherboard notjng changes. See the picture in attachment. Thank you IMG_20200601_120323 (768 x...

Hi!
Th temperature of hotend is ok. I put new termistor.Maybe is 5 degrees higher.But i can control it.
p.s is it possible to heat but only if a set the temperature at 72 degrees (on display 70/72).And the heat goes to max.