Geeetech

Hello,

Has anyone already tried to fit BondTech LGX Lite Large Gear extruder and TriangleLab Dragon High-Flow hotend to Prusa i3 Pro B?

Any STLs/ideas?

I can't seem to find any relevant projects on Thingiverse or anywhere else

Hello,

Has anyone already tried replacing the stock A4988 motor drivers with TMC2209? Are there any jumper changes required to do this or just the firmware config change? (i.e. X_DRIVER_TYPE, Y_DRIVER_TYPE, etc.)

Thanks!

Do you really run Windows 10 on your printer's logic board? That's something really new...

I believe that on this printer model the beeper is on the LCD/SD card board, not on the main logic board. I can totally get rid of it physically. But I was hoping that it's possible to disable it in the software and may be for one single type of event (the beeper itself can actually be useful when u...

Sometimes I may have a problem with nozzle or bed heating, caused by various reasons (mostly my experiments), but the reason is out of scope of the question. The question is: how do I disable the annoying beep noise which Marlin software produces when it thinks there's a sensor failure? I understand...

Just posting an update to my old post, in case it becomes helpful to someone else. Originally, I said that my underextrusion was happening on curved parts only, however later I observed it on other parts as well. After trying all sorts of alterations (firmware, filament, extruder, hot end, slicer, j...

aah, right. Sorry, my bad. First doing, then reading manual as usual... Well, it seems to work with GCode-provided and stored settings, so I'll leave it there for now
However, your README is very nice, as it lists many useful options as well, thanks! I'll bookmark it

Thanks a lot! That really helped :) Although, for some reason my printer didn't want to use neither calculated nor provided skew factor (I fail to understand why), but I was able to give the number via M852 S-0.016016 command and then save using M500. So a test square was printed with correct sides ...

Hi guys, Could someone help me with setting X and Y axis to the right angle? I have been using my i3 Pro B for a long time and for majority of printed parts it seemed fine. However, recently I've noticed that X and Y axes are not set to exactly 90° to each other. There's small deviation of may be 0....

First of all, thank you so much for the firmware!! Great stuff :) Just a quick question: I've uploaded the firmware by disabling the leveling (I don't have it yet), but homing always give -12 on X axis (Y and Z behave normally). X-stopper works perfectly, the printer detects it, but the coordinate i...