Geeetech

Hi there. My I3 pro b is finally working. I'm using Cura that i configured with the I3 profile found here, and a 1.75 white ICE filament. Temperatures are 205 / 60 degrees. Other parameters are default. I tried the two test pieces found here : https://www.thingiverse.com/thing:1278865 https://www.th...

Same problem here. I try to remove the curl and cut the end but no way, that almost never works. My method so far is to remove the fan which allows me to grab the end of filament and push it over the 2nd hole. https://ibb.co/gWfgNYP https://ibb.co/gWfgNYP But that's really annoying to do that each t...

Yup it worked and flashing was done successfully afterwards. Tx William.

Here are the news. I got a new motherboard that I correcly flashed with the latest Marlin firmware (there was no firmware when i got it). Then the printer boots and LCD shows usual menu. Then.... same as before... I re-did all the tests and still the board seems to send no signal whatever the driver...

Hi there, I got a new GT2560 from geeetech to replace the original one that was defective. I connected : - the old and new motherboard - on any of my 3 linux PCs - with 3 different USB cable and none of the computer is seeing a USB connection (like in "dmesg -k"). It was just the board and a compute...

Thanks for your reply William Unfortunatelly, i already checked everything you mention. Please check my initial post to see if my tries are not the same as those you say (it seems to me it's the same.) For point 1/ that i didn't mention, here is the picture of the jumper caps https://ibb.co/kXsFP3f ...

no inspiration anyone ?

(deleted)

Hello everybody, I'm a newby at 3D printing. I bought & installed the I3 Pro B, my very first 3D printer. At very first moves it seemed installation was (almost) ok: - When powered off, all 3 axis moves well without friction. - When powered on, motors are engaged. I can use the "Move" menu to have t...