Geeetech

Hello, I need to install the superplate to my A20M but I get some problems (there are no instructions that explain howe to do it) I suppose to use the clips but if I put them on lateral axis they go away during movement (they are pushed out by vertical support of Z axis) if I put them on the other a...

solved, it was just to right click to the element and decide with estruder has to print it...
in any case thank you

is there away no set it directly on Cura? (preferring not using gcode manual customization)?

ok but where could I found "mixer"? I cannot see it...

hello,
I'm using Cura 4.6 and I would like to know how to print using only the second extruder, it's annoying change often the filament when I mainly use two colors....
I tried to disable first filament on the menu above the model but it seems to not work...

I found that probably was caused by the software used for slicing, using cura and profiles found here for my printer, it prints fine.
however, thank you

Hello everybody, I just bought an A20M and printed successfully the example inside the SD card. Then I followed the manual to import the settings (both of printer - first part of 6.2 manual's section - and filament - Geeetech A20M PLA high.rcp - as well. Now I downloaded an stl file from thingverse ...