Geeetech

Here is the youtube link https://youtu.be/cJwVfxburag

It wont let me due to it being an MP4 however here is the link sharing link https://s.amsu.ng/TSgUOH7VuTPN

I just checked to make sure they were on the same horizontal axis. They are now, same issue. Goes down, but not up

I checked to make sure they werent cross threaded. The z axis goes down just fine. just not up

Yes they run synchonously without the rods and the stopping seems to be done. but ive already swapped the rods and the holds for them. I dont know what it could be, i thought that it was the x axis belt being to tight and pulling them inward but it does it with the belt off too. ive checked the rods...

What fixed mine was that i didnt have the x axis belt tight enough. Then it was a bit to tight. so i would go as tight as you can then try to back up the belt a notch or two. IDK if that helps at all. Im having issues with my Z axis now though :/

So i purchased the I3 Pro W as my first printer, probably should have gotten a prebuilt because im having a lot of issues. My Z axis is not working properly, i have leveled it and done everything i can to fix it on my own. I have put in the proper Z codes i believe however the right motor is rotatin...

I have figured it out. I just replaced the stepper driver

So i have the Prusa I3 Pro W. When i first got it, it came with a faulty motherboard so i got a replacement. got that set up, and everything now works except i can't get the x axis to go away from home. If i manually move it away from home it will go back to home but i can't seem to get it to go any...