Search found 5 matches
- Thu Apr 09, 2020 5:53 am
- Forum: Geeetech A20M
- Topic: A20M : what stepper driver it uses?
- Replies: 6
- Views: 12044
Re: A20M : what stepper driver it uses?
Will the stock board take TMC2208 or TMC2209 stepper drivers?
- Tue Mar 24, 2020 9:32 pm
- Forum: Geeetech A20M
- Topic: A20M w/ 3D Touch Crashes into to bed first try
- Replies: 5
- Views: 6708
Re: A20M w/ 3D Touch Crashes into to bed first try
Thanks again William, I had the 3 pin wire plugged in right without instructions, but I had the 2 pin wire backwards.
- Tue Mar 24, 2020 12:44 pm
- Forum: Geeetech A20M
- Topic: A20M w/ 3D Touch Crashes into to bed first try
- Replies: 5
- Views: 6708
Re: A20M w/ 3D Touch Crashes into to bed first try
This is the newest firmware: A20M_G05(CH340 Support 3Dtouch) | v1.1.8_02 ? | 2020-01-08|460 KB
I compiled my own earlier, if this one works I will just flash this instead.
I compiled my own earlier, if this one works I will just flash this instead.
- Tue Mar 24, 2020 12:40 pm
- Forum: Geeetech A20M
- Topic: A20M w/ 3D Touch Crashes into to bed first try
- Replies: 5
- Views: 6708
Re: A20M w/ 3D Touch Crashes into to bed first try
Thank you, I was still looking around the site for that, then I noticed a reply, again thank you!
- Tue Mar 24, 2020 12:25 pm
- Forum: Geeetech A20M
- Topic: A20M w/ 3D Touch Crashes into to bed first try
- Replies: 5
- Views: 6708
A20M w/ 3D Touch Crashes into to bed first try
I've had my 3D touch for quite a while now, never got around to installing it on the printer I ordered it for, so when my A20M arrived today, after printing a couple of things, I decided to install the 3D touch, took a minute to figure out how to plug it it, and maybe I didn't plug it in right. The ...