Geeetech

Hi William;

I found the problem was a cold soldier joint on the probe itself. Thanks for the response.

I finally got the 3D touch installed and the firmware updated to support the probe. However, when I hit auto home the probe moves to the center of the platter and starts the calibration process I assume. It lowers the probe and slams the nozzle into the bed. What am I doing wrong? I must not be sett...

thanks William
I was scratching my head on this.

I do not know what the reference to Fr=100% represents. What does changing the value of this do? Is it changed in the configuration folder or is it changed in the configuration.h file? Thanks

Yes, I can get the probe to work but the z axis is screwed up. I can't get the z axis to home at the base. I was hoping someone had a good configuration.h file that had solved this problem.

Tobi;

Did you get the auto bed leveling to work? If so where might one fine the configuration.h file and will it work on a older GT2560 V3 board?

I could not get Marlin 1.1.8 to work with my GT2560 V3 board. I loaded Marlin 2.0 Bug-Fix and it runs great. I have not been able to get the auto-Leveling routine to work in the configuration.h file. The probe is works just fine. Thanks in advance.

I could not get Marlin 1.1.8 to work with my GT2560 V3 board. I loaded Marlin 2.0 Bug-Fix and it runs great. I have not been able to get the auto-touch routine active in the configuration.h file. Hoping someone can post a Marlin 2.0 configuration with the touch sensor working. The probe is works jus...

I only can read 5.0 volts to the pins on this connector. What should be the voltage to these pins?

Does anyone know what resistances you should view on this connector?