Geeetech

thanks a lot, I was looking for something like this.
Plastic looks very poor quality...

inside it's worse...

I found the problem when I check the gap between idler wheel and gear :
one piece is broken...
what can I do to use the warranty?

1- I think yes
2- I don't know how to do that???
3- I check all my devices ti 1.0V

can you please tell me how to check the spring tension of the feeder ?

Hi,
it can work normally, but if i let it go without help it will start to noise and struggle... and the plastic will stop to flow...

Hi, My Extruder making noise and don't move after a few printing time. After cleaning the PLA and start the printing the first layer generally goes well, but after the noise is starting and I see the motor is struggling. It looks like a plastic jam... If I help the wire during the printing, it goes ...

Thank you. I had to change the power of the motor specially for z axis... So I am trying my first printing with the calibration cube and I find some adjustments to do... And also I have to understand why the printer has some difficulty to finish like the extruder don't have the strength to pull the ...

Hi, I'm a little afraid, I probably should to calibrate my printer I3 pro B. But in the firmware topic there is to much or not enough informations... Which firmware should I use : Marlin? Ramps? Sanguin ? 3d touch...? Should I check my threaded rod and modify the source code? How to know my rod... S...