Geeetech

Thanks. I am currently using your build of marlin. It's great. Thank you!

What is a good recommendation for a stepper motor that is quieter than the stock? I would like to make the printer a little more quiet.

Thanks

It is 2 pins. Just the connector itself is wider. I guess I need to cut the connector off the new fan and splice it to the connector of the old fan?

Thanks

Hi, I am trying to replace the cooling fan on my A10 with a 5015 blower, but the connector for the 5015 blower doesn't fit into the connector where the older fan connected into on back of the hotend. How can I connect the fan to the back of the hotend? Is there an adapter to make the connector fit? ...

The little marks on the side. It was hard to capture on camera. Thanks!

Hey everyone

I’m getting close on getting the benchy perfect. Would anyone have any idea on what is causing these marks on the side?

Hey everyone, Does any one have any suggestions on how i could fix the lines appearing in my prints? IMG-0244.jpg IMG-0245.jpg Below is my slic3r profile. I would greatly appreciate any suggestions. Thanks! # generated by Slic3r 1.3.0 on adaptive_slicing = 0 adaptive_slicing_quality = 75% avoid_cros...

Thank you. Let me adjust my layer height and see what happens.

Hey Everyone

I cannot figure out what is wrong. Everything I have tried to print the right side of the bed always has thinner first layer. I have the 3D Touch installed for bed leveling. See the attached picture of a primer line.