Geeetech

Sorry, i don`t know who you are i need to talk to Geeetech.... I don`t use probe even i receive NOW explanation The hotbed version of your printer is the Mylar version, not the glass plate. The distance between the hotbed and the nozzle is the distance between the two leveling sheets. so i have more...

The hotbed version of your printer is the Mylar version, not the glass plate. The distance between the hotbed and the nozzle is the distance between the two leveling sheets. Ok so its problem of Geeetech not my - i have only i paper with the wrong explanation. Mylar ruined because i try to do it li...

limit switch of the z-axis down its all-ready down - what is Mylar version? 2 papers it`s 1 mm?

also w\o sensor you can see i take manual Z to a minimum it`s after HOME and A20M_G04(GT2560V3+CH340)
https://www.youtube.com/watch?v=7DfpBfd ... e=youtu.be did toy see the video i have only 2 views!!!

A20M_G04(GT2560V3+CH340) its exactly w\o sensor - what you mean manual? i take it to lowest point with my hands - it`s manual?
I send the picture when i try to do home its lo low and no filament in the menu! Geeetech firmware is no good !!!

i install A20M_G04(GT2560V3+CH340 still z jumping https://www.youtube.com/watch?v=7DfpBfd ... e=youtu.be

https://www.youtube.com/watch?v=7DfpBfd ... e=youtu.be
z jumping
this is motherboard gt2560 v4

i raize and stabilize build plate but when i do home its go to low ..... its touch Z sensor i can't change to minus Z

I say Z jumpung i remove autoleveling what i do now?

in Z changing to ? Its connected i just lower it