Geeetech

Hi to everyone ... (I hope, this is the right place for this post ... if not, pls move) The issue: I tried to figure out my correct temperature for the Prints with the Geeetech-Filaments and ... so i used the "Temp Tower" from Thingiverse (https://www.thingiverse.com/thing:2493504). For those, who d...

Hi William ...

... that was fast

THX for the Screenshots.

(Where do you buy the filament with 5.00€/500gr. ?

Hi there ... ... first, this my entry-post in this board and i hope, i've chosen the right Thread. I bought me a Geeetech A20M and tried my first steps. First of all, i'll print a "calibration Cube" and therefore i use "CURA 4.4". Adding the a20M-profile in it was easy, i found it here in the commun...