Geeetech

The problem is that apparently every manufacturer creates their own pin layout, so you can not simply change the connections. The result is that it works properly. In addition, the documentation is inadequate, partially incorrect or is missing entirely. I rewired 2 SKR boards (V1.3 and V1.4) without...

see alot of people trying to install skr boards many of them without the skills required to do so that seem to hit road blocks every 10 seconds. it sound be noted a upgrade like this is very involved required rewiring as well as firmware programming and a bunch of trial n error to get it going. It'...

I'd say I got it. The conversion has been completed, firmware compiled and it is printing.
So far so good. But I think everything is still at the beginning of the test phase with me.

Hey hello, thanks for the tip. I didn't know that you could adjust the attraction. I'll deal with it in a minute.

Hello, I am currently converting my A10M to a Bigtreetech SKR V1.3 + TMC2208 UART with TFT35 V3.0. Everything is wired except for the filament sensors, which I will leave out until the board works properly. For now, I'll stick to the microswitches for the end stops. now i'm ready that all axes run c...