Geeetech

well - it's been quite some time since this question was raised - but the answer is pretty simple: you can define as many extruders with corresponding starting code in the slicer software... I did exactly what you are asking for in Cura for the A10M: 5 Extruders from 100%/0% to 0%/100% in 25% steps....

I have the Problem that the small board with the Micro SD Card Slot and the USB cable is broken. The SD Card Slot does not work anymore and therefore I cannot print offline anymore. The small spring in the Slot and some plastic pieces came out when I removed the sd Card - so it is mechanicially brok...

I measured everything with a multimeter and doublechecked the versions. I have three A30 printers with 24V PSU and all hotbeds are soldered with 24V connections. Hovever one hotbed is not heating up corectly and has insufficient power consumption! As I have the possibility to swap components between...

I have three A30 printers. I have the same Problem on one machine while the other two work fine! I swapped components to finally trigger the issue down to the heatbed itself. I even tried to resolder the connection cable - the problem is not the mosfet nor the PSU. When measureing during heating up ...