Geeetech

So I screwed up somewhere. I heard a pop by one of my front driver and saw the smoke. Now the led screen is blank and it will not connect via usb. Am I right that I fried the main board or is there some chance that it was just the driver (I know its unlikely but drivers are less expensive. This is t...

Can anyone point me in the direction of where to test the GT2560 v3.1 board for power going to the extension board?

So I was changing out the hotend fans and think I somehow shorted out between the 2 pins. I am reading around 5v between pins 7-9 and 7-11. Where do I go from here? I have 24V to the hotend. Is the likely spot of failure on the extension board or would that be the other mosfet?

William wrote: ↑

Fri Apr 24, 2020 10:26 am

Hi，if you need to change the direction of the motor,
you can refer to this:viewtopic.php?f=17&t=17037

thanks i somehow missed it like an idiot

Having some more thermal runaway issues with my heated bed. Is there any way to adjust these settings using gcode commands by chance? I dont really want to recompile the firmware. Running Verts 2+ Build 493. Also Ive got a a10m and changed to a non geared extruder. What specific lines do i need to c...

vert wrote: ↑

Wed Feb 19, 2020 10:57 am

can you record a video of exactly what is happening perhaps it will help me better understand what its doing and why.

I'll do my best to do that in the next couple days when I have a chance

What details would be helpful here? Glad to provide them.

vert wrote: ↑

Wed Feb 19, 2020 9:00 am

would be greater details to better understand what is happening but it is possible the default thermal runaway settings are simply to strict generally only allowing 2C drift i have it set to 5C with a 60sec window bit more relaxed setting.

I just installed a new glass bed on my a10m (link below) I was attempting to do a PID autotune for the bed as I have done before and if I try as high as 90C then I get thermal runaway. How am I supposed to fix this as I typically print with ABS? Im at a loss currently. www.amazon.com/dp/B07F6CLTD7/r...

Running an A10M with verts Marlin Dev build 466 and Cura 4.4. Any time my bed goes to the front (away from the y axis limit switch) it goes too far and grinds. its not much but enough to need adjusted. Where would setting be to adjust that?

reading MAX temp means you shorted it. marlin is programed to prevent use in both these cases. replacing the thermistor seems the best action there like 1$ all day on amazon. something like this? looks like the right plug and all, just cut to length and resolder wires? https://www.amazon.com/Printe...