Geeetech

I am also starting to experience some extruder heating issues. The extruder temperature has been stable at 193 but during the last brint it has started varyingh between 170 - 220, and jumping around a lot. Is there a place to find tips on how to test this, to look for shorts and poor connections? Co...

I also always adjust the bed (z=0) before starting a new print so that the paper rubs between the bed and the nozzle. But I can see that the paper does not pass between the nozzle and the bed each time that I start a new print. Does this mean that the table is moving during the printing or is it no...

My prints were looking exactly like this on my A10. The resulting parts were weak, low-density, and stringy. I tried increasing or decreasing the temperature and this was not the solution. What I needed to do was to calibrate the extrusion stepper motor steps/mm. This is a pretty easy process you ca...