Geeetech

As I noted in my original post I've checked and reseated all of the wiring, so this isn't a loose wire issue. And the hot end is brand new, and came with the thermistor and hot end heater wires already attached. Is there anything besides that that could be causing the incorrect temperature reading? ...

I had a short between the two wires of the thermistor on my A10 that resulted in a dead GT2560. I replaced that board, but now the E1 temp shows as -14C and when I try to start a print it heats the bed, then fails with a "HEATING FAILED PRINTER HALTED please reset" error on screen. I've since replac...

Does anyone know what cable I need for the connection from the GT2560 to the extruder extension board? And where I can get it?