Geeetech

Hello, I have questions about the Config.h of the Marlin 1.1.8 Support BL Touch. I would like to have the BL Touch activated in the current Marlin version. but I do not know which lines need to be changed. I have deb A10 with V3.0 board With the Marin Config.h which is older I don't know if it is po...

I found the error why the error messages came. it was up to the programmer it was wrongly selected. AVRISP MKII I needed USBtinyISP. And it's already on the board Marlin 1.1.8. Now I will try to calibrate the OFFSET.

As soon as I loaded the Marlin 1.1.8 Complimentary Original Packet from the mold. I get this message every time. In file included from C:\Program Files (x86)\Arduino\hardware\arduino\avr\cores\arduino/Arduino.h:28:0, from sketch\MarlinConfig.h:38, from sketch\configuration_store.h:26, from sketch\co...

Is this file with BL?
2.Geeetech A10 with GT2560V3 board

A10_marlin1.1.8.zip
(2.65 MiB) Downloaded 2543 times

The BL Touch makes its pen test in and out when the printer is turned on. but it is apparently not in Marlin Active switched and thus you can not see it on the printer display as a function because it is probably not activated in the script.

Marlin 2.0.x has strangely only Marlin / Configuration.h and Configuration.adv.h. /** * The BLTouch probe uses a Hall effect sensor and emulates a servo. */ //#define BLTOUCH /** * Touch-MI Probe by hotends.fr * * This probe is deployed and activated by moving the X-axis to a magnet at the edge of t...

how can I attach the config.h as an attachment?

Hi, I have problems with the Marlin 2.0.x The BL Touch is not active in the Configuration.h. I already tried it with #define enabled. The complication shows errors. I've tried several times to flash the Marlin 1.1.9 on the GT2560 v3 motherboard errors are always displayed. their Geeetech Configurat...