Geeetech

I found great nozzles MK10 M7 thread and 2mm inner diameters and they works great ! Choice from 0.2 to 0.8 mm (shipment is around 3 weeks) Here : https://fr.aliexpress.com/item/33009261245.html?spm=a2g0s.12269583.0.0.1f8b7199qx2ZB7 Thanks. I might be ordering some of these. I have heard some things...

Hello. I received my TMC 2208 Geeetech. Could someone guide me to installers on my A20T please. Thank you https://www.geeetech.com/images/v/Geeetech_20190215104545.jpg I don't have TMC2208 but I'm looking at maybe upgrading as well. But it should be pretty straightforward. Replace the old modules m...

Fixed it! One of the rollers was very loose (the one that looks gray because it's covered in graphite), it would have been impossible to fix without disassembling anyway, as it was on the back and the screw was just not reachable. Had to remove the bottom cover to unplug the bed power cable and then...

Fixed it! One of the rollers was very loose (the one that looks gray because it's covered in graphite), it would have been impossible to fix without disassembling anyway, as it was on the back and the screw was just not reachable. Had to remove the bottom cover to unplug the bed and then remove the ...

My bed was loose, the entire part with the bed leveling section and the bed itself wiggled slightly side to side. So I tried the official instructions from Geeetech: https://www.youtube.com/watch?v=l1r-sv8zIb8 All this did was start to unscrew the screw and nut on either side of the middle piece, th...

My bed was loose, the entire part with the bed leveling section and the bed itself wiggled slightly side to side. So I tried the official instructions from Geeetech: https://www.youtube.com/watch?v=l1r-sv8zIb8 All this did was start to unscrew the screw and nut on either side of the middle piece, th...

Old topic but here are some very interresting informations. Retraction on mixing extruder just do not work as expected, and this is the key of stringing problems. Basically when one side/filament is retracted, it suck from the other side/filament rather than from the nozzle , that's why the retract...

William wrote: ↑

Fri Jun 21, 2019 9:18 am

Hi, The nozzle type of A20M is m7 thread, It is not the standard MK10 4mm inner diameter nozzle. You need to check it at first. The default inner diameter should be 2mm.

It says it is M7 threaded, though I'm not sure what MK10 means.

Just assembled the A20M, added the 3dTouch, uploaded the firmware to support the 3DTouch and homing or autoleveling puts the nozzle into the bed and the Z motor starts clicking. Ordered this from 3DPrintBay. Printer has while accents instead of blue and there is no glass bed, did I get an old model...

I'm looking to grab some hardened steel nozzles for my A20M, and I'm wondering if anyone's found one that works well with the A10M/A20M. I found these, that look like they would fit: https://www.amazon.com/PrimaCreator-PC-NVP-04Hx4-MK10-Hard-Nozzle-Nozzles/dp/B07CKXT7DD/ref=cm_cr_arp_d_product_top?i...