Geeetech

Same problem here. Also frustrated and making a lot of tests with bad results.
Would be good to get some advice and to know how to meassure stepper engine current.

@jarda3d what do you mean with "extruder case" ? My extruder has no case... I don´t know any extruder with case... please, clarify.

Do you know any link?
Because I can´t find it.

Thanks.

I refreshed the firmware and everything went back to normal.

Hi,
Is there any wat to upgrade my A10 to an A10M?
What do I need?

Thanks a lot in advance.

Regards
Federico.-

Hi Willam, It didn´t stop in the middle of printing. I was printing something and I canceled the job. Then I selected auto home and then I turned the printer off, everything as usual without any issue. One hour later, when I turned the printer on I found this behaviour. (the display shows two lines ...

Hi William,
Thanks for your answer.
I think the screen cable is ok.
How should I proceed to refresh the firmware?

Thanks and regards.
Federico.-

William wrote: ↑

Mon May 27, 2019 9:56 am

Hi, Do you mean is it a word that wants to be hollowed out?

Yes, exactly!

Hi, My Geeetech A10 was working ok. I stopped a print job and turned the printer off. Later, when I turned it on it does´t start, and the display shows two lines of black blocks, as can seen on the enclosed image. Any hint on how can I make it come back to life? Any help will be much apreciated! Tha...

Hi, I am facing similar problem and the display is showing two lines of black blocks as seen in the enclosed picture. My Geeetech A10 was working ok. I stopped a print job and turned the printer off. Later, when I turned it on it does´t start, and the display shows nothing, as you can see on the ima...

Hello, Anyone knows how to avoid printing the first layer or to avoid the infill in the first layer with Repetier/Cura? I am unsing an Geeetech A10 and I need to get rid of the lines inside the text. As seen in the screenshot before slicing is ok but after slice lines appear inside the letters in te...