Geeetech

When I purchased my A20M it came with the Geeetech 260mmx260mm SuperPlate (glass) and the heatbed was 260x260x1.5mm. I noticed on the newer revision models, the heatbed is still 260mmx260mm, but its much thicker, appears to be 4mm thick (probably reduces heatbed warping significantly) and a Mylar St...

I've been having a very similar issue, Really not sure how to fix it. My assumption is that you use one extruder more than the other? Since this printer is a mix printer, its meant to blend or swap colors constantly. Is there a detailed schematic of the 2-in-1 out feeder? Reason I ask, is if there i...

Yeah, the tube is fitted to the teflon tube quick-detach all the way into their endstops on both the hotend and the feeder. I also took out the quick-detach and nozzle to check if there was any built up melted or leaking filament, everything is clean. I'm also still getting alot of oozing during war...

By "Did you dismantle the Teflon bowden tube completely" Do you mean, did I dismantle the old feeder attached to the Stepper motor? Yes, the plastic gear on the E0 metal gear/driveshaft was slipping when the gearshaft rotated, somehow they had separated since its not 1 solid piece. (the left hand pr...

I bought the Aluminum Feeder upgrade for feeding the filament into the Bowden 2-1 hotend, and have had problems since. https://www.amazon.com/gp/product/B07KQ6FVS3/ref=ppx_yo_dt_b_asin_title_o02_s00?ie=UTF8&psc=1 I am using the Firmware with 3dTouch from this forum. The two filament feeders are usin...

Is there a list somewhere of all valid G-Code commands you can add/adjust into your slicer?

Right, just caught that. Saw the Gcode start/finish boxes in CURA slicer for printer settings. I wish I had the knowledge of how to use the code, so that when starting a print it sets the bed, and keeps the nozzle on far left so any oozing that happens doesn't land on the build-plate. Since adding i...

OK, so these would be code lines to alter in the Arduino code before compiling? correct?

I bought a A20M printer, been using it on win-10 and printing from the SD card. Been using Fusion-360 to create models, and Cura-4.0 to slice to *.gcode files to the SD card for printing. I later purchased the official auto leveling sensor, 3d-toutch. Arduino (MARLIN) 1.8.5 firmware is updated, and ...