Geeetech

LOL, okay, now I understand...... Are you kiddin? This printer was the most expensive printer on the market but most of us decided to buy this because of some special hardware. Now, since one year, nothing happened to get this tool stable. I often write down some mails and also to some developers bu...

Dear Geeetech Team, since more than one year I owned a DP200 and of course I have a lot of issues with it. The Slicer, the Web-GUI, burning CPU while downloading large files,... Did you stop research?

Dear all, I have the issue that I have a enourmous Backlash in Z Axis. I can move the Z-Glider for about 2mm up and down without moving the Stepper. Any ideas how to tighten the Z-Axis?

There are big issues with the current firmware while slicing . Most of the slices timed out and the printer won’t react anymore. For this you have to poweroff and reboot the system to get control over the Web GUI. Also there are problems with transfer of „larger“ files >40MB. Sometimes it fails comp...

Hey all, any updates on DP200 Printer? Me and some other users have big issues on slicing and preparing prints.

Hi William, not really. I also tried to use the auto leveling sensor but it is not as accurate as I wanted to have.
This also does not help with my problem because the shift becomes bigger and bigger with every print. In some time the shift is high enough to break the X Axis.

Hello all, I have some issue on my A30 with the two steppers left and right. For first I have to say that both stepper drivers are adjusted to 0.9V Vref. Anyway, after a long print for about 10 hours there is a shift of the hight between the left and the right stepper motor (at least 3mm between lef...

No, I have not. Which frequency works for A30?

Hi all, I tried to add a Beep to my G-Code with multiple parameters (M300 S500 P500) but it seems not to work but this G-Code is also part of the valid G-Code list. Did I make a mistake or is this command not implemented yet?

Same here. I measured 4,2Ohm between Pin 2 and Pin 3. If I calculate with Ohms Law it is around 130Watt but absolutely no 260W. I ordered a new heatingbed from Geeetech but same problem. The maximum temperature I can reach is about 83°C and it is not possible to print ABS with this. Do you have a so...