Geeetech

vert wrote: ↑

Mon Mar 25, 2019 1:41 am

there is a workaround using standby temp to keep it heated when switching.

Yes I have been using that workaround. Looking for better

Cura doesn't support this and they have no plans to do so. Have a look at this thread for a simple solution or the more complicated way here (check attachments) which i haven't tried yet. I'm not trying to mix I want to use only extruder 2. I'm sure cura does support this because like I said I did ...

William wrote: ↑

Fri Mar 22, 2019 10:14 am

Could you try to test this gcode?
We need to refer to the result then give you the suggestions.

Not sure how to test a gcode other than printing it. Can you give a little more detail? Keep in mind I'm still pretty new

Hi all so I've been using my a10m for single extruding and all is fine unless I want to use extruder 2 alone. If I use only extruder 1 everything works right. Bed heats, nozzle heats then prints but when I slice a model to use only extruder 2 the bed heats and then it starts trying to print. I have ...