Geeetech

I figured out a workaround. I only need one extruder motor now, I won't be using mixing anymore and since the thermistor sensing circuit of E0 doesn't function correctly (probably the mosfet or a resistor died), I checked the schematic and the pinouts of the board and found out that E1 has its own h...

Thanks for the info Vert

Is there any way for the board to be repaired? Could you point out which SMD components are responsible for temperature measurements?

Hi William,
I tried that, it still shows 200. In the past I remember it showed briefly -14, and then 200. Why -14?

On December 2018 I got a Geeetech A10M. It was working pretty much okay, after few months one of the Titan style extruders broke, so I replaced both of them with BMG style extruders from Triangle Labs. However about one month ago I had hotend issues, the temperature was fluctuating frequently and I ...

I usually upgrade the firmware from Linux using Arduino IDE, with no issues so far. However when I used Windows and the firmware toolkit, the printer worked again, thanks.
I guess something went wrong with the usb drivers on Linux.

I have another problem too, I'll open a new thread for it.

I tried other versions of firmware, I tried upgrading with and without an sd card. Didn't make any difference. I tried M502 & M500, no luck.
The screen & menus are unusable.
How many rewrites can the eeprom handle?
I'm not using octoprint

Hello, I have a Geeetech A10M for about a year. It was working fine. I tinkered and uploaded the firmware numerous times in the past with no problems. However after the last firmware install, the printer became unresponsive and throws a lot of crc errors. Any ideas how to fix it? Slic3r.png echo: Ex...