I switch back to the Firmware without 3dtouch and no all worked well as before
So there must be a bug at the Firmware with 3d touch
BR Harald
Search found 5 matches
- Fri Mar 08, 2019 10:57 pm
- Forum: Geeetech A10 Series
- Topic: A10 with Marlin 1.1.8 not printing after 3dTouch upgrade
- Replies: 4
- Views: 8529
Re: A10 with Marlin 1.1.8 not printing after 3dTouch upgrade
Update,
I switch back to the Firmware without 3dtouch and no all worked well as before
So there must be a bug at the Firmware with 3d touch
BR Harald
I switch back to the Firmware without 3dtouch and no all worked well as before
So there must be a bug at the Firmware with 3d touch
BR Harald
- Fri Mar 08, 2019 10:13 pm
- Forum: Geeetech A10 Series
- Topic: A10 with Marlin 1.1.8 not printing after 3dTouch upgrade
- Replies: 4
- Views: 8529
Re: A10 with Marlin 1.1.8 not printing after 3dTouch upgrade
No idea guys? Should I flas the A10 without 3dTouch again to check if the Firmware is the problem?
BR Harald
BR Harald
- Fri Mar 08, 2019 7:39 pm
- Forum: Geeetech A10 Series
- Topic: Marlin 1.1.9 firmware for A10M (pre-built, fine-tuned, both with & without 3d touch) by aarli
- Replies: 33
- Views: 147335
Re: Marlin 1.1.9 firmware for A10M (pre-built, fine-tuned, both with & without 3d touch) by aarli
Hi vert,
thank you for the information.
BR
thank you for the information.
BR
- Fri Mar 08, 2019 7:04 pm
- Forum: Geeetech A10 Series
- Topic: Marlin 1.1.9 firmware for A10M (pre-built, fine-tuned, both with & without 3d touch) by aarli
- Replies: 33
- Views: 147335
Re: Marlin 1.1.9 firmware for A10M (pre-built, fine-tuned, both with & without 3d touch) by aarli
Hi,
is it possible to use this 1.1.9 with A10 normal not A10M ??? If so, can I update the Firmware with the Geeetech update tool?
BR Harald
is it possible to use this 1.1.9 with A10 normal not A10M ??? If so, can I update the Firmware with the Geeetech update tool?
BR Harald
- Fri Mar 08, 2019 5:06 pm
- Forum: Geeetech A10 Series
- Topic: A10 with Marlin 1.1.8 not printing after 3dTouch upgrade
- Replies: 4
- Views: 8529
A10 with Marlin 1.1.8 not printing after 3dTouch upgrade
Hi all guys, I did yesterday a 3dTouch sensor to my A10 and put the new software from this side to the board. All worked fine and also bed leveling worked well. But as soon I start a print from SD card, after Autohome, automaticaly Z setup and heating of bed and nozzel there is only a bar running on...