Geeetech

sss wrote: ↑

Sun Mar 17, 2019 12:16 pm

Alxo wrote: ↑

Sun Mar 17, 2019 12:28 am

Give the knob a gently push and you will see the menu, select prepare and then auto-home

Well, holding and turning the knob does not make the menu selection on the panel.

Hold? It is a push, just as a regular button

I only use PLA and I've never printed above 60 and usually I use 50, I don't think it is a temperature problem. I have always cleaned it with 96º ethilic alcohol and a cotton cloth, nothing else, yesterday I bought isopropilic alcohol as recommended. As I said it seems to be an obgoing process even ...

I attach a picture of the bed. I insist that I'm not cleaning it hot, I did a couple of times at the very beginning

I have observed 2 different problems: - I've just started printing, however the bed seems to be losing its skin and looks like very old. Is it a problem with the bed, with my settings or that my nozzle is too low and scratches the skin? Should I worry about it or it is just aesthetic?I couldn't get...

I have observed 2 different problems: - I've just started printing, however the bed seems to be losing its skin and looks like very old. Is it a problem with the bed, with my settings or that my nozzle is too low and scratches the skin? Should I worry about it or it is just aesthetic?I couldn't get ...

Give the knob a gently push and you will see the menu, select prepare and then auto-home

This thread is very interesting. Currently, I am learning how to control my A10 but I have a second hot end, which I was thinking of using to be able to combine 2 different filaments. I think I only need a second extruder motor and then it should not be a major issue to configure the second nozzle i...

Update, I switch back to the Firmware without 3dtouch and no all worked well as before :!: So there must be a bug at the Firmware with 3d touch :cry: BR Harald I had the same problem, use Arduino IDE 1.8.5 to upload the firmware you can find in the official thread (I haven't tried later versions fr...

Using Arduino 1.8.5 was the answer. I managed to use the printer with the BL Touch. Now I'm fighting to get the proper settings of the printer.

William wrote: ↑

Mon Mar 11, 2019 2:21 pm

Hi,alxo
I strongly suggest checking the "Note" again.
Try to upload it via Arduino IDE 1.8.5

Thanks for the reply. I have the 1.8.8. I'll try again with the 1.8.5