Geeetech

Does the inital layer look like it's under extruding? Doube check the filament size setting in cura matches the exact measured diameter of your filament. Leveling with paper didn't yield consistent results for me. The initial layer would print thicker than 0.2mm even though it's set to .15mm in cura...

Looks like you were right. I took the cover off the controller box and the print completed.

Guess I will have to figure out a way to improve the cooling of the controller

Hello again, A10 running Marlin 2.0 with 3D touch and TMC2208's. I attempted my first larger print, 4+ hours estimated to complete, and the print stopped part way. LCD is frozen/hung and dial doesn't respond. Nozzle and bed remained heated. First attempt was on build 245. I thought maybe a bad flash...

That's good information.

Thanks.

Hi, I'm brand new to 3D printing and this is my first machine. My A10 is running on Marlin 2.0 build 245 with 3D touch and 4 x TMC2208's. I did a manual bed level first and my initial layer thickness looks nice and even. My test print is a 160mm disc. As soon as I run the Auto Probe and Save, the pr...