Geeetech

Thank you, yes I found the PDF of the schematic
To my mind Open Source is providing both the Schematic and Board layout in a common PCB design software format.
Hence my question

Hi,
I may be wrong, but is the GT2560 V3.0 open source?
I thought I'd read somewhere that it was.

However, I have been unable to find any design file for it, so I'm now thinking it's not open source.

Thanks
Sean

Hi William,
So you have analysed the G code and fixed it. BUT that means the GeeeTech Color Mixing Software is faulty. Correct? LOL

Hi William,
Do you have an update? While not an urgent issue, it would be nice to have an answer as to why it worked for you but not me.
Sean

Hi William,
What did you find?

Ok, here is the output G code.

So, William, are you still asking me to upload my G code files? If so, can you please explain your logic? Because I am lost as to why you do not accept that the input file is the same as the output file. I am asking for help and an Admin quite happily says the software work for him, but does not off...

That's great William, the software works for you. Your vase walls seem to be quite thick, so perhaps the software works when the wall thickness is over a certain value. The G-Code being imported compared to the G-Code that is being exported is the same. So you can look all you like but you won't be ...

Just been told on another forum that the colour mixer software does not work in vase mode!

Really no point in attaching the G-Code. You can use any G-Code produced by Slic3r to check to see if the software modifies the G-code.
I did try and up load the files, even though they are the same, but the site will not allow the files to be added. Invalid file extention.