Geeetech

Tks a lot Jarda3D. But i miss to indicate that i use Cura, not Slic3r. I'm unable to find your end_gcode in .ini files.

Hi everybody, Since the beginning of use of my A10M, my printer don't move the bed out of the printer to easily remove the printed part. I've tried lot of end-code, but each time the bed move well out then without any reason it go back to the rear until it hit the end course switch, then stop. This ...

Tks _kaktus_
Any idea on where it could be ?

Hi team, I'm unable to move plate to the front of printer to easily remove the print. Seem's that end Gcode is well executed, the plate move well to front, then after 1s, it move back at full speed the rear of the printer…. This is my "end" Gcode (collected directly from the .gcode file is use for t...

Hi Fugly, tks for your answer.
The printer work fine before i apply fw and install 3D BLtouch, then i assume that ends stop work fine.
Agree that there is something wrong in Marlin 1.1.8. modified with 3D BLTouch, but where ??

Hi Team, I've just install the Geeetech BLTouch option on my brand new A10m. 1rst I've flashed printer with version 1.1.8 with BLtouch following lot of discussion available in this forum successfully. I'm using A10M_marlin1.1.8.zip available in Download section of this forum and Arduino 1.8.5. Also ...