Geeetech

Thanks kaktus, turned out it was a bed level issue.
Posted my finds in the a10 series posts.
Cheers mate

Have you got this printer and find it near impossible to level? Check your bed bolts, I found that every time I wanted to print, I had to level the bed again, most times I found it hard because a corner would run out of adjustment. I removed the bed from the machine, there was a fair bit of friction...

Hmmmmm, i have not got anything bad to say, i think support has been great, all my questions have always been answered promptly, my replacement glass bed and heat tray which arrived to me in melbourne within 2 weeks. thank you Geeetech, you rock

Oh!!!!!!
I also use the geeetech parts paper to set my height, It seems to be a different thickness than an A4 sheet, If you had a good quality gloss print paper, that also adjusts height good.

Dont know if I am too late with this post but, I had the same issues, I have now increased my extruder temp to 210 degree, my glass bed at 75 degree and I now use a very sticky hair spray,,,all is perfect for me now.

I found the same thing, just using the tension screw fixed them both up.
What is ramen money?

Thankyou so much for sending me a replacement glass top and assembly, after I fitted them, it levelled up nice and easy, now I am getting full prints. Now I have no doubts about the A10M and the girls are getting ready for their first print tonight. Thankyou all again, I am over the moon, the old be...

Thanks for that.
Every time I am nearly finished printing any of the blizzard, dog or cone, the object always moves, is this normal.

I have had this printer for 1 day now, Not frustrating, more excited and liking the challange of learning, this is my very first 3d printer and no of nobody with one. So far, after 4 failed attempts of printing, i found that after leveling, I start the print, then I adjust the height slightly while ...