Geeetech

I did bump the VRef up to 1 and it did help some... will keep playing. Thanks!

You can buy dual drive Bondtech BMG clones for $20-$25 on AliExpress. I purchased two for under $40 a month ago and received them last week. They are a direct replacement for the inadequate extruders that came with the machine. I actually will be posting a little review shortly.

Another hour or two of troubleshooting. Swapped the entire E0 post hotend assembly (motor/extruder/FTFE tubes/couplers) for the E1 assembly and the same symptoms prevail. At this point I think I have pretty much eliminated any other possibility and I believe that the left side of the hotend (the sid...

I own three 3d printers, the A10m being my latest. I like a lot about this printer and have gotten some great prints using the dual extrusion. This isn't meant to be a rant but I would like to get some real advice on how to get this thing working better. My A10M performs beautifully until I attempt ...

FYI: I didn't futz around with the firmware or load the software mentioned/referenced in my OP to change the extruder directions. The wire pairs were as I thought, and I swapped one set per extruder motor to get them to reverse direction. Basically, it's a 6 pin/slot connection with no wires in the ...

I purchased some new extruders for my A10M that will require that the extruder stepper motors get reversed. I know you can alter the firmware to accommodate this but I would rather just re-pin the motor wires. IIRC you can flip the entire plug or just repin and swap one coil. My extruder motors are ...

If it isn't mechanical like you believe it might be then it's time to dive into settings. I had trouble with layer shifting in the y-axis when I began configuring my slicer software and fresh off of a firmware update. My issue was the acceleration and jerk numbers were really high. Once, I lowered t...