Geeetech

Never mind. I find the info further down the forum list.

I'm looking to a 3d Touch to my A30T but can't find any info on the pinout for the extension board. Can you provide a picture of the ABL wiring at the back of your hotend or direct me to where to find the info? Thanks.

I can't get my bed level manually. I wasted several days trying to get the platform level without success. The four corners are now good but the center is still not sticking well. I did not have this problem before I disassembled my hotend due to a clog. I'm totally puzzled and at the point of givin...

This is a Geeetech forum. But having said this, I think the Ender3 is a better choice. It has a slightly larger bed (220mm vs 210mm for the i3), better review, and a larger community for support. It is also cheaper according to the Amazon lightning deal. There is always a good possibility the someth...

Measured from right to left, my x axis is approx. .5 -to 1mm higher on the right side. How much deviation from horizontal is acceptable? The next question is how do I adjust the tilt? I do not see any way to adjust the 2020 extrusion. None of the screws appear to be adjustable. My bed is also tilted...

SOLVED. The bottom of the plate which the 3 wheels are attached was slightly bent outward/backward. The eccentric spacer could not compensate for the increased distance between the bottom wheel and the 2020. I was able to bend the plate back flat by hand. The hotend unit is no longer just hanging lo...

How tight is the hotend unit suppose to hang on the 2020? There is alot of movement on mine but I don't know how to tighten the wheels against the 2020 extrusion. If I manually push the hotend up slightly, the top two wheels are barely even touching v-slot on the 2020. There is an eccentric spacer o...