Geeetech

Maybe this is solution for you:
https://www.youtube.com/watch?v=OLGSz6XT76s

In these kind of printers, when overheating, they might behave erratic. One of the additional signs is odd behaviour of the LCD. LCD has a separate processor. This happens rarely. So, do check wiring, as it might obstruct air flow in the main box. Check if all the fans are working. But first of all ...

Hi. You are invited to watch videos about Geeetech A30 3D printer. Videos will be published according to my publishing schedule. At the moment there are several prepared: 1. Unpacking, comparison to Creality CR-10S PRO and general problems with the printer. I also discuss WHAT NEW PRINTERS is GEEETE...

Smartto could be way better than Marlin, but it should be made for Arduino. IAR workbench is to expensive for general public to work with. The migration to Arduino would give Geeetech a high number of contrubutors... It is not that hard as it already is in C and may parts of the code are from Marlin...

Hi all. William, your FW update corrects moving in X and Z axis. The movement in Y axis works too, as it did in officially published V1.58. After updating FW, I only had to change motor directions in the settings. So, thank you, my printer A30 is now silent. For those interested, I make youtube vide...

Hi all. William, your FW update few posts back corrects moving in X and Z axis. The movement in Y axis works too, as it did in officially published V1.58. After updating FW, I only had to change motor directions in the settings. So, thank you, my printer A30 is now silent. For those interested, I ma...

Hi.I also have 3.2HW, STM32 board and FW58 on my A30. X axis does not work on TMC2208 while other axis are OK. I have reversed motor direction, but X goes in the wrong direction - to the right and stays there. Reversing direction does not change anything. It must be a FW problem.