Geeetech

@Gingko Hello I have seen that post before. I checked the board and port and everything was correct. I then unplugged everything except the usb cable from the board and tried to upload it but again had no luck. I checked the crystal oscillator and from what I can see it appears to be fine. The solde...

I have a geeetech I3 Pro B. I had a problem with one of the z axis motors not working (the functioning one switched when i switched themn on the control board so its not the motor) and looked on these forums where it suggested to re-install the firmware. I tried doing this using the correct firmware...

I have a geeetech I3 Pro B. I had a problem with one of the z axis motors not working (the functioning one switched when i switched themn on the control board so its not the motor) and looked on these forums where it suggested to re-install the firmware. I tried doing this using the correct firmware...