Geeetech

Hi Willian,
Thanks for the reply.

I tried what you suggested but it just kept extruding it did not stop at 100 mm. The touch screen display looks different.

Firmware is V1.35.56


Robert

Hi,

can someone please explain how to extrude 100 mm of filament so I can calibrate the extruder?

I can not see anything on the touch screen to do it.

Thanks

Robert

Hi, Calibrating the printer with smartto, z axis and thought I would check the extruder. 1. How do you get the printer to extrude 100 mm of filament? 2. Smartto ver 1.0? did not find settings. Tried ver 1.2? And it loaded some settings. The motor steps were in red 000.000 so I just typed the setting...

Hi William do you have the part number Or link for the board that I need for the touch sensor so I cab buy it from your shop?

Hi,

Thank you for the reply William.

So the board will be ok for the touch sensor when I solder the 5 pins in?

Robert

Hi, just upgraded from Geeetech I3 ProB to a A30 and a good move. I want to instal a 3D Touch which I thought would be plug and play, but do research it does not seem that straight forward. To install I need to 1. Remove 3 pin socket and install 5 pins see pic's Extruder Top.jpg Extruder bottom.jpg ...

Update
Machine all working some problem with firmware and computer not talking to printer so installed laptop as smoepone ? error.

All working now.

thanks for the help.

Robert

Hi William, I tried swapping all the motors connections around etc but no luck. I even tried a new driver board with no luck. I did get a motors to work properly after I pressed the failsafe on the LCD. Each time I move a motor I need to press failsafe. The LCD also sowed hit endstop. When I start t...

Thanks for the reply William. Not sure what you mean by check if the motor line of each axis is connected to the corresponding position. I checked the voltage and all set to 1.2 volts. And 5 volts The x and y motors are moving the extruded at a speed of 30 mm per minute. The z motors not sure of spe...

Hi, Was setting the z offset and the steppers started making a noise so turned the machine off as I though it was hitting the glass. Started up again and noticed the software was saying 10 commands waiting and I noticed the Steppers not moving. Gave up at this time. Next day checked baud rate etc st...