Geeetech

Good evening honestly I could not solve the problem, I tried different solutions but without result, I still use the self-leveling sensor, but then the self-leveling sys-off, G29, and manually level the plate. I will still be on the net and I will try other solutions, I hope sooner or later to succe...

Good morning I inverted the threaded rods and the Z-Steppers from the right side with the left one, but the result does not change, the plate is not aligned in the four points B and C are at the right level for the extruder, point A is too high the point D is too low and the material does not stick ...

Thanks, I had not thought about it, I will try to reverse both threaded rods and Z-stepper right-left, to see the behavior.
Greetings Massimo

Good evening, it's the first time that I connect to this forun, I have a Geeetech I3 Pro B gt2560 rev A + After having assembled everything to work correctly both molded PLA and some attempt with ABS, then I perform upgrades for self-leveling. I bought a 3DTouchAuto Leveling Sensor, I installed it a...