Geeetech

Hello, I think it's done, it was a struggle to understand the endstops but learning as we go walking, even then I'll have to tweak the step motors better, a few things, but I'm glad I think this board is quite sturdy, and it seems to me an excellent board for future projects. Thanks https://youtu.be...

Hello here it is alive, at this moment I still have not printed the test, I tested the endstops and the slow movements the motors do not heat and the drivers heat up but not much, only a long impression I will know if they heat up. I use 1/8 steps for the extruder also, on the Z axis 1/16, just to e...

Hello well, it's almost finished, I hope tomorrow to print the test if everything goes as planned, I use the S3D needs adjustments. The photos and videos go slower, but I'm preparing them. I like to give names to things, and as of 2 I did 1, I decided to call it "GTrEborn", as I said, some time ago ...

Hello, I'm trying to put some photos through the Imgur but I do not know if I'm doing it correctly, I've already configured the firmware and the endstops, it will be necessary to make some adjustment, but only when I start printing, I'm going to prepare the extruder. I chose this name because this p...

Hello How do I post some photos here on the forum? when I say table I mean heated bed, I already adjusted the voltage of the driver, at the moment I am preparing the firmware, I am having problems with the endstops but after 300 times I am ALMOST to arrive. there is a lot of information on the inter...

Hello I have already solved the problem of 24V + 24V, and the jumper, but the table does not fall below 34ºC, it warms up without problem but it does not go down, I will check the firmware, or PIDTUNE I do not think it is damaged. can I set the table directly on the GT2560? or do I need MOS module? ...

Hello I want to transform a ctc Replicator 1 by putting the GT2560 rev A with 24V, but I'm confused because the i3 pro B has 12V but it is powered by 4 wires that comes from the power supply (2 red, 2 black) and both have 12V , which makes 24V impossible because the power supply is 12V 15A. Correct?...