Geeetech

Unfortunately that doesn't seem to work. When filling in the outlines of a cube it fills in in thick then thin sections creating a weak print. It's almost like half of it is extruding correctly while the rest isn't.

When I started my first few prints everything went well, but I'm now experiencing some issues. I'm getting lots of gaps and the filament seems to get caught up around the extruder nozzle and then pulls off the print bed. It also curls up around the nozzle when it starts to extrude. The only way I ha...

That did the trick - many thanks :)

Thanks for your replies :)

It turned out that the thumb screw for adjusting the bed height was making contact with the rear of the printer before the bed had hit the axis, I adjusted slightly and it all now works as it should.

I finally have managed to get everything successfully connected to my PC and started moving everything around in Repetier Host. I have one issue, when homing the Y-Axis the bed hits the end stop but the motor keeps going and makes a horrible noise as it struggles to pull back a bed with no room to m...

I have a I3 Pro B and have just finished assembling the printer and tried to get it to connect to my PC. I have installed Repetier-Host and the drivers (CDM 2.12.00) as specified by the website as it didn't not automatically install. My printer is still appearing in device manager as under 'other de...