Geeetech

Thank you William,
this is the best one so far!
I am not able to try it fully for the next month due to being out of the country but when I do, I will feedback.

I've checked to the relevant information, I found that the problem lies in the extension board. Do you have a multimeter? Maybe you should check its output port. I think you'd better not wire the extension board, but connect it directly to the GT2560 motherboard. Then you can upload the fw for the ...

Hi, I have a Geeetech i3 Pro A 3 in 1 control box GT2650 Rev A+ and I have two 3DTouch and one BLTouch from my other printers and all working on thoes. I have tried several ways to get the 3D & BL Touchs' to work on this i3 Pro A but I seem to fail all the time. I see many of the Geeetech printers n...

Ok, I've now gone and purchased BLTouch -Smart V2.2 as I broke the last 3DTouch when trying to home then the pin dropped etc etc… on my Geeetech i3ProA (Aluminum with separate control box) with a GT2560 Rev A+ board and have it working in test commands, but when I go to Calibrate the Z-Offset I get ...

Well done!!!!! I have been trying for ages. I'll give your Marlin a go and follow your other threads on youtube etc and x fingers

Hi, there Tired of leveling your heat bed manually? Would you like to add an auto-leveling system for your printer? For me, the answer must be "YES". Now,here comes our protagonist: 3D Touch Sensor QQ截图20160921155546.jpg QQ截图20160921155515.jpg Her chief features are: Simple,Smart,High-precision,Inn...

Come on Geeetech :evil: It is about time you helped us i3 Pro A (with the separate control box) users out with decent firmware that works and that Geeetech have tried to get BL Touch or 3D Touch working on one of these. I have all the wiring sorted and the 3D Touch works on all the G code commands f...

Any New Firmware for the Geeetech 3D Purusa i3 A Pro with separate control box, that lets the BL / 3D Touch actually work? I know that it has all the settings in the Marlin and have followed all the instructions on the forum, website and other forums. I have got the probe going up and down and self-...

I do hope you can help please, as I have been trying to sort this out for the past 12 months. Thank you for posting but is there any chance you could post one for the original A4988 and auto bed leveling enabled. Mine has a 3D Touch. https://www.thingiverse.com/thing:2039119 And I have set the setti...

Has anyone yet got the 3D Touch working on the Aluminuim Geeetech Pro A with the GT2650+ board?
If so please could I have a copy of your firmware as this has been doing my head in for 6 months now!!!