Geeetech

Do you use Cura software for slicing?

I also had this problems when I used Cura slicer.
With any other slicer printer is working without problems.
Now I am using IdeaMaker.

I am using this anti tremble "things" and everything is now silent.

https://www.thingiverse.com/thing:3111251

I totally agree with Mitch95.

I also have A30 and it is solid made but problem is firmware which is not Marlin.
In Marlin firmware you can change lot of things to make your printer better but with Smartto firmware you can only wait geeetech to release new firmware (if ever).

Hi,

I am using something similar. I remixed CR10 fan case with two 120 mm fans, but i didn't disconnected all fans.
I just disconnected power fan and removed power supply cover.

http://www.thingiverse.com/thing:3712312

Best regards

I bought two of this on ebay and they work without any problems.

Because I set bed leveling manually there is no point of taking video. Now on video you can not see anything. I really do not want to readjust bed again to make a video. My Z offset iz set to -1,4 with M851 command (also tried set it trough configuration.h file). These are readings after G29: 08:51:...

I have a problem with setting 3D Touch. I tried with every firmware that I found. I also tried with a capacitive sensor. 3D Touch and Capacitive Sensor work smoothly. After the G29 command I get the measurement results. Thereafter a problem occurs. At a point where the head should go down, it raises...

I can not see on the video is pin down (because red light is on which means that pin is up).
If pin is not down I think only problem you have is that your sensor is too low.

Raise the sensor a bit and everything will be ok.