Geeetech

boothbenny25,

You can find my configuration here:

http://geeetech.com/forum/viewtopic.php ... &start=240

Beware it is of a 3D Touch sensor, not a inductive one.

Marco, I used a Usbasp as a programmer. How to copy the old hex and flash the bootloader can you find in: http://geeetech.com/forum/viewtopic.php?f=18&t=19120&start=50 I think your error is that you first have the Uno flashed as a programmer or taking the wrong step to burn the bootloader. For flash...

Some people don't get it.

This is a forum and not a course to setup and flash Marlin for newbies. Go to study the Arduino IDE and Marlin documentation to find out and to get the basic knowledge you need to get the job done.

You can find Marlin here: http://marlinfw.org/meta/download/. You have to configure it and to compile it for your printer and to use auto bed leveling. You can find enough examples in this forum and on the Marlin site.

It is a good custom to clear the eeprom settings after you uploaded a new firmware with new configuration, so the old eeprom settings will not get in the way.

You can use the stock Marlin. Release versions are found here: http://marlinfw.org/meta/download/ There is also a Marlin github available with the latest sourcecode. My printer is running by Marlin 1.1.3. It runs fine. You have to configure Marlin and compile it for yourself, see the Marlin site, th...

Pes0001,

What version of Marlin are you using? Try the new one like 1.1.3 or 1.1.4. Worked fine for me.

Also check your wiring and pin config. They should match.

If you buy a metal extruder suitable for a teflon tube and a suitable motor mount, you can install your existing extruder motor at the top of the printer, I did modify the existing extruder cooling a bit so it fits on the top mounted extruder, because the motor will quite hot and otherwise the filam...

07BF, My "secret" is bidding on ebay. This way I can reduce cost quite a lot. I have good experience with it. Normally no shipping costs. I switched from cura 14/15 to cura 2.5 because small holes in the print were mostly oval, not round. This is solved in cura 2.5. This moment is to get a 20 hours ...