Geeetech

3DAngel wrote: ↑

Sun Sep 08, 2019 3:32 pm

I might have issue with my eye lately.... but I could not find your config anywhere...
would you be able to post it, it would help me and others.... thanks

It's on the first post.

E Motor tends to get hot. Just to be safe I switched back to the original driver just for the extruder and now it runs cooler.

Hi, my LCD panel works just fine with klipper

I can confirm, sometimes the deploy fails with 3dtouch.

Currently using it at 60 to 80 mm/s with pressure advance enabled and auto bed leveling.

Unscrew = counterclockwise
Screw = clockwise

Hi, I have an A10 with GT2560 Rev. 3.
I'm using TMC2208 drivers and I would like to setup the Extruder one in UART.
Does anybody know what pin should I use on the motherboard for tx and rx?
Thanks

Yes you are. Be careful and hold the motor with one hand because those screw keep it in place.

That datasheet is wrong for our motors. The axis motors are 42SHD0034-20B (note the two zeros) and are 34mm in lenght (not 48mm). Other than that, with an amperage of only 0.4 per phase, the extruder motor alone, who's the biggest with 40mm of lenght would give us ridicolous vref: 0.8 x 8 x 0.05 = 0...

Hi, killvearn. Have you some links to klipper fw upload on A10? It's simple like Marlin with Adruino IDE, or need somethingh else? Hi, it's a whole different kind of firmware. It uses a raspberry pi with octoprint to process the gcode and uploads a micro-firmware on the board, making it just an int...