Geeetech

i'm looking for a firmware for my i3 Pro X with working BLTouch support( Geetech Clone)

i have an i3 Pro X, what to change to use this firmware ?

so i would need a new board , to support 3 Extruders ?

or is there an extention board avail/ planned ?

I would like to have an upgrage kit form Singel extruder to 3-to-1 diamond hotend

Questions

1: how to get the GT2560 Rev A+ i use to get 3 Extruder working ? (it is designed for 2 Extruders)

2: how to mount the hotend ?

3: how to add auto level - BL Touch sendor to mount ?

yes black + white are connected to z-min pins.h -> i followed the instuctuion of the pdf for Rev A+ so i did /***************************************************************** * Ultimaker pin assignment ******************************************************************/ #define Z_MAX_PIN -1 //32 #de...

@daveapplemotors: the ligth is off + pin extended, but see for yourself https://youtu.be/mPHlSE_rdmE

I if i do G28, the sensor pin is going down, the z is going down, if the pin touches the bed , the pin is going up, led switches to red, but z is not stopping

i have an Pro X ( GT2560 RevA+ Board )with Firmware from the 1st page( + changes for the GT2650 Rev A+) + Setup like described on the wiki + mount for the sensor from the wiki. M280 Po S10 + S90 + S160 are working. if i do G28 -> y,x work, then it goes to the middel and z is going up 3mm, G29 -> the...

my plastic mk8 extruder is only "working", if i put preasure on the fillament by hand. what i checked already: 1) temp checked - OK( i set is to 200 °C ) 2) motor working - yes 3) steper motor driver 0.83 V - changed to 1V - but no change 4) i have no "little srew on the top of lever" , i bourgth my...