Geeetech

Is this configuration good for i3 pro c ?

I purchased from Aliexpress. I did send and hope they understand me.

Hello i broke the Hot end screw and i ordered from geeetech a replacement i ask them to send me the exact same hotend with the screw as that come original with the printer. they send me not the same piece and they say it is the same. I send them picture and they don't seem to understand. can someone...

Hello

I have calibrated the extraction length correctly for one extruder but the second one extrude less. is there another setting on top of that.
here is my setting #define DEFAULT_AXIS_STEPS_PER_UNIT {78.74,78.74,2560,107.95}

thank you

Oh Darn

I will not do this i will probably damage the board.

If someone know a way that it could be done without soldering, it would be amazing.


Thank you

Hi

I am trying to follow instructions on how to connect the 3DTouch to the board of the geeetech pro c GT 2560.

Everywhere it say to connect the 3 pin connector to the z-max ( the board have only 2 pins on z max )

anyone done that already ?

Driver module was defected I replaced and all ok for now. will do more testing.

Thank you all especially to Geeetech support with the idea to switch between modules.

Sorry for the late response.

so now the printout sticks ok to the plate, starting to print ok then slowly shift to the left. please check the video and let me know what you think.

https://youtu.be/GSIhXKMd6oQ

Ok so i found the problem. It seems that the double extruder is a bit going toward the front ( fan). Whenever i lift toward the back it then works ok for a minute but then it start sjipping steps. Any recommendations ?

What would you recommend as a setting ?