Geeetech

Hi. I have got the level that my prints are good enough, but now I'm experiencing problems with my prints warping and bending in middle of print. In short, the problem seems to be in heated bed temp... Is my bed broken or should I adjust temp meaning set higher and check my infrared temp meter? 56 r...

Found that it should be done in firmware, so I found that and updated my motor directions. Now this works fine.

Thanks

Can not find anything in settings.
As I read about similar problems there were some suggestions to change wires for motors, but thats not possible in my case. It does not go in if around.
Some said it should be changed in firmware but I'm not sure where and how.

Any suggestions ?

Thanks

Newopint95 wrote:you need to reverse the direction of your X and Y motors.

Hmm thanks did not knew you can do that. Going to check settings where can I do that

Hi. Can somebody help me ?
It seems something is wrong because when I try to Auto Home it goes to wrong side I guess what makes not good noise.
Check some video: https://www.dropbox.com/s/i79605yp7ihin ... 1.mp4?dl=0

What could be problem ?

Thanks

bang wrote:Did you fix it?
I'm suspecting the endstops are not connecting well.

Hi. Yeah I fixed this problem and get my first failed prints , but i still suspect that there is some more problems.

I will post some pictures and make new thread about that.

Thanks for answering

Hi to all. I have weird problem. I have got my printer Geeetech Acrylique Reprap Prusa I3 Pro B 3D All seems works, and I'm able to connect to printer, but when I try Manual Control: http://i.imgur.com/YobaXk5.png Only + works on all axis. When I press - nothing moves on printer. What could be probl...