Geeetech

I'm not exactly sure what was going on. I went back to my default tested firmware and it loaded fine with 1.0.6. Then I found a previous version of the Marlin 1.1.4 and tried compiling that without any changes and it worked fine. So I re-read the original post on this thread and saw that Arduino 1.8...

Hi, I haven't messed with firmware since I bought my printer but decided to do some upgrades (lead screws, 3DTouch) and came upon this thread for firmware. As I recall, I had an issue with Arduino versions and uploading then, but 1.0.6 was what I ended up using to get the stock firmware to upload. W...

When you load pins.h, it will open Marlin.ino. You then have to go to the down arrow on the right side of the screen in the tabs, click on it, then scroll down to pins.h. It's not very intuitive. After seeing this, I thought to myself that maybe it was the Arduino version i was using. I was on ver....

You have to load it first So is there a special method other than "open" then navigate to the Marlin folder and selecting pins.h and then clicking "open"? Cause every time I do that, it just opens marlin.ino. It should be at the last point measured. I'm not sure about why it reads 0,0,0 but mine do...

For posterity, after you load pins.h, you have to go over to the little down arrow on the row of tabs on the far right side of the screen. Click on it and it and scroll down until you find pins.h. Yea, I figured out what that little arrow was for, but pins.h still does not show up as a tab. Using A...

OK, arduino newb here! I have done the wiring and mounting but have not connected anything to the board yet as I'm stuck editing the firmware. So far I have opened the configuration.h and made all of the changes in the instruction manual. All good. But now I have come to the pins.h part. The instruc...

I know this is an older post, but I have no voltage at the PWM socket but when I check for voltage across pins 1 & 2 on Pin 16, I get 0v fan off and 4.36v fan on. Would there be any other reason why I wouldn't get voltage there? Note: Never mind, I just figured out that the wiring diagram is incorre...

Hi, I just found this thread when I was searching for a solution to a similar problem. In my case my X was working but Y would only go + and Z would only go +. The limit switches were indeed the solution but I installed them as they looked like they should be in the assembly instructions .pdf. After...