Geeetech

Bonjour le_joebar Désolé pour ma réponse tardive, j'avais laissé tombé et j'avoue ne plus être revenu sur le site de Geeetech. Donc, j'ai fait je pense tout comme sur la vidéo, mais ça ne marche pas, l'aiguille remonte bien dans la "seringue", mais n'est jamais libérée: elle ne descend donc jamais, ...

I actually, after my previous post, found out that my pin did not have a smooth surface and sometimes got stuck (blinking LED) . I removed the grub screw and the pin and then very, very carefully polished the pin. Do not damage the heat shrink. Reassemble and it should work fine. Mine has been runn...

I spent (well... lost) all my sunday on this little s...t and IMHO, it is just a mechanical or electrical problem. The 3DTouch is reacting to the G-code orders, but the pin doesn't go out. If I don't put the screw, the pin goes up and down, but if I put the screw, even very loose, it sticks on it an...

Hi flunk happy to read that some people reach to make this 3DTouch working. Mine is always blinking. When I tell it to push the pin, it just vibrate a little, and then it is in error because the pin stay inside, even if I turn the screw up or down. What is your secret to have it working? Can you hel...

Hi everybody, I am new in the forum. I am French, I bought a I3 Pro B, I want to add a 3DTouch on it. First af all, I received a 3DTouch with a bad connector, since the orange wire was on the pin which is supposed to receive the 5V+. I changed it to comply with the marks on my board, which is GND-SI...