Geeetech

Hello William, thank you again. I downloaded the fw and uploaded but nothing. I've checked the board mentioned, my one is considered ULTIMAKER, changed but nothing. Checked the pins, corrected, but nothing. Even the printer was not moving as before. So I've given up for now, moved out the probe, sti...

Marlin.7z I think you can try to use these code check it work or not 1.M280 P0 S10 M280 P0 S90 M280 P0 S120 2.If it still won't work,you should check the fw of yours correct or not ;) Hello William, thanks again, I followed your suggestion but nothing. When I send the G-Code instructions using Simp...

Hello William, thanks again, I followed your suggestion but nothing. When I send the G-Code instructions using Simplify3D interface I don't obtain any reaction. The probe is up and solid red, if I manually extract it the red light is turning off but nothing else. I've checked again the firmware but ...

Hi william , I've a I3 Pro B and I've installed the 3dtouch probe. I followed all the instruction for installation, wiring and firmaware changes. When I turned on first time the probe it has done the self test succesfully remaining in solid red. I've changed the script in Simplify3D putting G29 aft...

Hi william , I've a I3 Pro B and I've installed the 3dtouch probe. I followed all the instruction for installation, wiring and firmaware changes. When I turned on first time the probe it has done the self test succesfully remaining in solid red. I've changed the script in Simplify3D putting G29 afte...

Hi wwysocki, I have a Geeetech Prusa I3 pro B, I've already upgraded it with T8 Lead Screw and solved very well wobbling problems. Finding tedious to manually level the bed I've installed the BLTouch also. I followed the instructions for installing, wiring and Firmware changing but even if the self ...

Hi Craig,
yes, the seller confirmed he's organizing the shipping.
I will share the results.

Regards

Maurizio

Hi there, I was investigating on the bad print quality. I've uploaded one picture. It is visible the first layer, in right position but with very poor quality (printed with the config file of GEETECH), the second layer shifted respect the first one (this is the effect of the lost steps and irregular...

Hi there, thanks for the replay. Yes I swapped X and Y and I rechecked the Voltages. Around 1V on all except on the X one, so the issue is following the A4988 stepper from Y to X. I tested the movements manually and it's clearly the X one now erratic. Y is moving well now. I will ask for support. Re...

Hi there, I have a problem with the Y DRIVER on my Acrylic Geeetech Prusa I3 pro B 3D Printer DIY kit. After the assembly I corrected the firmware because the X motor was moving in the opposite direction solving the issue. After that everything was working apparently well and I made the calibration ...