Geeetech

The results are the same no movement of the extruder axes at 180deg celsius

I send a video at technical support and to mr wang mail

I ve check the tension between the screw and the ground i ve got 1,1v the stepstick is ok the motor is ok the wire is ok do you have an other test to do ?

I use prusai3b the test i made are without the nozzle
I just try to make turning the motor shaft without success
I put the hot end at 180 not to have any trouble with température check

Hello i ve new trouble with my printer the extruder axes doesn t work I set the hot end at 180•c ok then if i use the display panel to use the extruder nothing happen I made a try plugin my motor on the y axes the motor work I made a try using an other stepstick nothing change I made a try with an o...

sorry i get the answer by e mail by some one of your technical support in fact it s the normal way of working when i made the test the nozzle didn t start heating until the heat bed arrive at the temperature i have had some mistake a few time but but not a regular trouble it works deferently after a...

hello thanks for the answer great support
i made the try and in effect it works i was wrong

hope not to deal with you again even if it s one of the best support i met
thanks

hello,
i ve send the video and reinstall all the settings
without more success so for me there is 2 alternative the
sd card reader or the board
if you have an other idea
bye

hello i first believe in sd trouble i make a try with an other sd card without success but yes it s look like bad reading or interpretation of Gcode (ok for bed wrong for nozzle) my seller give me an email contact in support and to mr WAN...... to send them the video hope you ll get it also for the ...

i can t send you the video i made because you refuse the mp4 attachment the trouble is that when i start a print the temperature of the nozzle stay at 0°c(set in slicer at 210°c) after a stop of the print if i restart usually it s the nozzle goes at the right temperature210°c it s quite rare that th...