Geeetech

I do nothing with it.

It is as was at delivery time.

I thought that it is integrated in the bed inside...

If it should be on surface then it never was there.


So what is Your sudgestion? What I should say to seller?

Haralds

Hi!
There are measurements

Hi there is pictures.

Resistance measurement shows there is no connection.

With original wires, attached too and measured directly too.

Haralds

Yes! I check it. Both wires are alive.

Haralds

Hi!

ok!

I agree non heating the hot bed is not a board problem. It works.

I connected the hot end and hotend termistor in place of hot bed and it works.
I connect the hot bed and left connected the hot end's termistor and hot bed start heat.

What You can advise for this case?

Haralds

Hello! I checked the f I short the termistor end on board repieter shows 301 deg.C. On heated bed I don't see any damages or disconnections. Sorry but You didn't say anything about heating of heated bed. What is about it? We have following facts: 1) resistance of heated bed is out of specification. ...

Hi! Are you reding te posts and check the information in attached files ???? 1) in video You can see the changes of screen ! In video I am changing the potentiometer and You can see how it changes... I have uploaded latest firmware of board. No changes. 2) I said previously "6) I swap the thermocoup...

Sorry screen shoot wasnot attached.

There is it.

1) LCD I checked the wiring it is correct. I swapped no changes. Screen while adjust the potentiometer check out the video. Later on I will try complete the firmware option. (On moment I have not time for it) 2) heated bed temperature screenshoot attached 3) x-motor I swapped X axis drive with Y axi...

1) LCD
I checked the wiring it is correct. I swapped no changes.

Later on I will try complete the firmware option. (On moment I have not time for it)

2) x-motor
I swapped X axis drive with Y axis drive. Now Y axis is clicking.

Haralds